Setting up
9 - 4
9
.03
Feed rollers and hot-air pressure, heat-sealing temperature and speed
●
Switch the machine on.
Before changing the feed roller and hot air pressure, the pressure on the
appropriate regulator must first be set at
"0"
. The required pressure can then be
set.
Hot-air pressure
(only for machines with hot air):
●
Set the hot-air pressure on regulator
1
according to the material of the workpiece (at least
0.3 bar
).
Before switching the main switch on, make sure that the hot air pressure is
above
0.2 bar
!
If the hot air pressureis too low, the heating switches off automatically.
Feed roller pressure:
●
Set the feed roller pressure (see Chapter 7.10) according to the material of the workpiece
(
max. 5 bar
).
Heat-sealing temperature:
●
Set the heat-sealing temperature on buttons
2
according to the material of the workpiece
- hot wedge model max.
550ºC
- hot air model max.
650ºC
.
●
Display
3
shows the required temperature and display
4
the actual temperature.
Heat-sealing speed
●
Set the heat-sealing speed (see Chapter. 7.07) according to the material of the workpiece
(
max. 10 m/min.
).
1
Fig. 9 - 05
2
4
3
Fig. 9 - 04
Summary of Contents for 8304-020
