Pevino PI24S-B, User Manual

Page: 14 / 63

14
TEMPERATURE SETTINGS
Important: The LED-display indicates by default the actual internal air temperature.
The electrical circuit board of all models comes with memory function. All settings will return to the pre-set
temperature after power is restored.
NOTICE!
It is important to understand that there is a difference between the air temperature inside the wine cooler and
the actual temperature of the wine.
Once the temperature is set, it is strongly advised to let it settle and not adjusting it frequently. You will need to
wait approximately 24 hours before noticing the effects of temperature adjustment due to the mass, volume and
density of a full wine cooler.
The thermostat will maintain the temperature inside the wine cooler within a +/- 2.5ºC range. But the thermal
inertia of the wine and the glass is such that within this temperature range, the actual temperature of the wine
will only fluctuate 0.5ºC to 1ºC.
DISPLAY BOARD - OPERATING INSTRUCTIONS
For PI24S-B and PI24S-S
○
,1 Power and light ：
In standby mode: Press and hold for 3 seconds. Power is turned on and the system starts.
When running: Short press this button. LED lights on/off.
When running: Press and hold for 3 seconds. Power is turned off and the system stops.
○
,2 Display:
Indicates the actual temperature inside the wine cooler.
○
,3 Temperature setting (circular function):
At each press on this button, the temperature inside will drop 1ºC, until arriving at lowest possible setting, and
then a return to the highest temperature. You can continue this in a circular interval within the range of available
temperature settings.
○
,3 ºC/ºF display conversion:
Set the displayed temperature to degrees Celsius or Fahrenheit at each press on this button.