PEUGEOT Kisbee, Workshop Manual

Page: 56 / 76

ELECTRICITY
54
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
„
Regulator/Ignition unit
- Remove the rear cover assembly. See:
Procedure 2. page 20.
- Removal:
• Regulator (1).
• The ignition module (2).
„ Checking the ignition system
Disconnect the ignition unit and perform the
measurements on the harness
side (3 Connectors).
If the values are correct, replace the ignition
module.
If the values are incorrect, check:
- The harness.
- The ignition switch.
- The high voltage coil.
- The magneto.
- The transmission sensor.
Component Connector Wire colours Standard values
Ground A Green_Ground R = 0
:
Ignition switch:
Ignition on
Ignition off A
A Black_Green
Black_Green V = 12 Volt (Battery voltage)
V = 0 Volt
Engine cut-off B White/black_Green
Ignition on:
f :
Ignition off:
:
Drive sensor C Blue_Green
R = 145
:
±20%
Ignition sensor A Yellow/blue_Green
R = 145
: ±20%
Low voltage coil B Red/black_Green R = 517
:
HT coil:
Primary
Secondary
A Yellow/black_Green
High voltage wire_Green
R = 0.5
: ±20%
R = 3.7 K
:
±20%
Spark plug socket R = 5 K
:
2
1
xxxxxx
xx
xxxxx
xxxxxxxxxxxx
Ω
A
B
C