www.petsafe.net 5
Fit the Bark Control Collar
Important: The proper fi t and placement of your Bark Control Collar
is important for effective operation.
To assure a proper fi t, please follow these steps:
1. Make sure that the Bark Control Collar is turned off.
2. Start with your dog standing comfortably.
3. Place the Bark Control Collar high on your dog’s neck
close to the ears. Center the Sensor Probe underneath
your dog’s neck, touching the skin. Make sure the
YES
NO
PetSafe
®
logo in the front of the unit is upright. Note: It is sometimes necessary
to trim the hair around the Sensor Probe to make sure that contact is consistent.
4. The PetSafe QuickFit
™
Collar is designed
so you can quickly attach and remove the
Bark Control Collar from your dog while
maintaining the desired fi t.
a. With the Snap Buckle fastened, thread
the collar through the Metal Buckle.
b. Slide the excess collar through the “C” Loop on top of the
Snap Buckle. This will hold the collar in place.
c. Once the collar fi t is determined, simply use the Snap
Buckle to remove and replace the collar.
5. The Bark Control Collar should fi t snugly, yet loose enough
to allow one fi nger to fi t under the strap. Allow your dog
to wear the collar for several minutes, then recheck the fi t.
Check the fi t again as your dog becomes more comfortable
with the Bark Control Collar.
6. Trim the collar as follows:
a. Mark the desired length
of the collar with a pen.
Allow for growth if your dog
is young or grows a thick
winter coat.
b. Remove the Bark Control
Collar from your dog and
cut off excess.
Important: The Bark Control Collar should not be worn for more than
8 hours out of every 24-hour period.
