8
Customer Care Center 1-800-732-2677
To Insert and Remove the Batteries
Note: Do not install the batteries while the Indoor Bark
Control is turned on.
1. Holding the grooved edges, slide the battery tray
out (
A
).
2. Install two (2), 3-volt (CR2032) batteries positive (+)
side up (
B
).
3. Slide the battery tray back in place (
C
).
To Verify the Batteries are Inserted Correctly
1. Slide the On/Off Switch to ( | ) ON (
D
).
2. The LED should flash green once and there will be
an audible beep. Then the LED will flash green once
every 5 seconds (
E
).
3. If the LED doesn’t flash, you may have inserted the
batteries backwards. Try taking them out and turning
them over, ensuring that the (+) side is up.
4. If the LED still does not flash, contact the Customer Care Center.
Replacement batteries (3-volt, CR2032) can be found at many retailers. Contact
the Customer Care Center or visit our website at www.petsafe.net for a list of
common retailers.
C
B
A
E
D
