Petsafe PBC00-11283, Operating Manual

Page: 9 / 16

petsafe.com 9
To Fill and Refill the Spray Collar
• Remove the Spray Collar from your dog.
• Turn the Spray Collar off.
• Ensure the refill port is clean. Note: If any dirt or debris enters the refill port when refilling, it could
cause the unit to become clogged and malfunction. Please read the “Tips and Maintenance”
section for proper care.
• Hold the spray can upright and firmly press the nozzle down into
the Refill Port. Hold for 15 seconds and remove. Note: If spray
leaks out, you may need to press harder to complete the seal.
• Turn the Spray Collar on.
• For optimal performance, the Spray Collar should be refilled
before each use.
Resetting the Spray Counter (recommended after each refill):
1. After refilling the spray, turn the Spray Collar on.
2. The Spray Collar LED will turn green for 1 second.
3. Next the LED will turn yellow for 2 seconds.
4. As soon as the yellow LED disappears, turn the Spray Collar off.
NOTE: You must wait until the yellow LED disappears before
turning the battery to the OFF position. If you turn the Spray Collar
off too quickly (prior to the yellow LED disappearing), the Spray Collar will continually blink
yellow indicating it is in the test mode.
5. Wait 2 seconds.
6. Turn the Spray Collar on.
Do not puncture or incinerate the Spray Collar or the refill canister. Do not
expose to extreme heat or store at temperatures above 113°F.
Refill canisters are available in citronella or unscented spray. Contact the Customer Care Center
or visit our web site at petsafe.com to locate a retailer near you.
Testing the Spray Collar
NOTE: Keep the Spray Collar away from your face during testing.
1. Turn the Spray Collar on.
2. The Spray Collar LED will turn solid green for 1 second.
3. Next the LED will turn solid yellow for 2 seconds.
4. As soon as the LED is yellow, turn the Spray Collar off.
5. Wait 2 seconds with the Spray Collar off.
6. Then turn the Spray Collar on.
7. The LED will flash yellow to indicate that the unit is in test mode.
8. During the flashing of the yellow LED rub the Spray Collar with a coin to create a vibration.
After it has sprayed, it will have a time-out of about 10-15 seconds before it can be tested
again. After approximately 1 minute, the LED flashes green to indicate the Spray Collar is
now in normal operation again.
15
seconds