www.petsafe.net 7
Operating Guide
Step 1
Install the Barrier Transmitter
The Barrier Transmitter emits a radio signal from all sides in an elliptical pattern. The signal may transmit through a wall or
the ceiling/floor. The Barrier Transmitter can be placed laying flat on a surface or hung on a wall. If you choose to hang the
Barrier Transmitter, note that the signal becomes very directional—the signal will be strongest directly in front of and behind
the unit. The signal is weakest to the side of the unit.
Do not:
• Hang unit on a metal wall
• Place Barrier Transmitter on metal surfaces
• Place Barrier Transmitter near large metal objects such as refrigerators, washers, etc.
• Place Barrier Transmitter near audio speakers
Set Up the Barrier Transmitter
Step 2
1. Turn over the Barrier Transmitter and rotate back cover counter-clockwise,
removing the back cover. Install three AAA alkaline batteries and replace the
back cover. Turn clockwise to secure cover.
2. Turn the Barrier Transmitter right side up and press the (+) button once to turn ON the
Barrier Transmitter. A black bar in the upper right hand corner of the LCD display window
indicates that the Barrier Transmitter is set to mode A* (
2A
). A second black bar in the
bottom of the LCD display indicates the range is set to one segment.
3. Each segment represents approximately 12.7 cm from the unit. You can create a
Barrier Area of 12.7 cm to 76 cm from the unit. Using the (+) and (-) buttons,
adjust the range to fit the desired pet Barrier Area.
To prevent an unintended correction, never perform set-up procedures while your pet is wearing the Receiver Collar.
2A
