Petsafe Drinkwell PWW00-13705, Operating Manual

Page: 6 / 16

Customer Care Center 1-800-732-2677 6
OPERATING GUIDE
1. As with any electrical device, check
the electrical power cord for any tears
or damage before use.
2. Make sure the in-line plug is
connected ( Fig. 1).
3. Place the foam filter around the
pump. The rounded side of the foam
filter should be directly in front of the
faceplate on the pump. Make sure the
electrical power cord runs over the top
of the foam filter, not underneath it, as
this will keep the foam filter in place.
4. With the foam filter securely around
the pump, place the pump inside the
indention in the bowl. Position the
pump so that the circular opening
on the top, is in the upper right hand
corner or true center of the bowl
( Fig. 2). Press down on the pump to
engage the suction cups. Place the
intake tube into the circular opening
on the top of the pump (
Fig. 3).
5. Align the cone so that the power cord
runs through the power cord notch
( Fig. 4) without moving the pump from
its original position. Once the power
cord is aligned, gently place the cone
piece into resting position.
6. Take the partially assembled filter
housing and remove the flow control
cap by gently lifting straight up - DO
NOT TWIST TO REMOVE (Fig. 5).
Gently lift up and remove the spout
ring to access the filter housing cap.
7. Rinse the charcoal filter thoroughly under cool water before
placing into the housing. This will remove any loose charcoal
dust, which is harmless to your pet. A small amount of
charcoal dust may be gradually released for the life of the filter.
This is normal and not harmful to your pet. The charcoal filter
should be replaced every two weeks for best performance.
Filters may need to be changed more frequently depending on
the number of pets using the pet fountain.
8. Unscrew filter housing cap and insert the filter into the filter
housing with the pull-tab facing up ( Fig. 6). The filter will slide
easily into place. Next, screw on the filter housing cap.
9. Look into the cone opening and make sure the intake tube is
sticking straight up from the pump (
Fig. 7). Carefully, insert the
filter housing into the cone opening and push straight down
(
Fig. 8). By pushing the filter housing all the way down to the
rubber gasket, the housing should easily attach to the intake
tube.
• Do not use outdoors. Do not run dry. For
indoor household use only.
• Do not pull on the electrical power cord to
remove the plug from the electrical outlet.
• To unplug, grasp the plug, not the
electrical power cord.
Fig. 1
Fig. 2
Fig. 4
Fig. 3
Fig. 5
Fig. 6 Fig. 7
Fig. 8