Petsafe Drinkwell DOGCCN-RE, Operating Manual, Page: 7 / 40

www.petsafe.net 7
T-CN
S-CN
EN
Operating Instructions
Important:
DO NOT RUN DRY - FOR INDOOR USE ONLY. Pet Fountain will come
fully assembled and ready for use.
1. As with any electrical device, check the electrical cord for any tears or damage
before use.
2. Inspect the bottom of the Pet Fountain to be sure the Pump is securely attached
(
fig. 1
).
3. Remove the Housing Lid and insert the Charcoal Filter. The Charcoal Filter will fit
diagonally into the Housing. The Charcoal Filter fits narrow side down, with the
black side facing the front of the Pet Fountain (toward the spout). The Charcoal
Filter will slide easily into place, but make sure it is pushed all the way down
(
fig. 2
).
Important:
Rinse the Charcoal Filter thoroughly under cool water before placing in
the Pet Fountain. This will remove any loose charcoal dust, which is harmless. A small
amount of charcoal dust may shed for the life of the Charcoal Filter. This is normal and
not harmful to your pet.
4. Place the Pet Fountain in desired location before adding the reservoir. Never pick
up a full Pet Fountain by the Housing. Only pick up the Pet Fountain by placing
both hands underneath the base of the Pet Fountain and grip the sidewalls for
a sturdy hold. If placing on carpet, tile or wood flooring use a protective mat or
other durable, water resistant surface to protect your floors from splashing or
dripping caused by the pet.
5. Before you plug the Pet Fountain in, make sure the Power Cord and your hands
are dry. Plug the Pet Fountain into an electrical outlet.
6. Fill both the Bowl and the Pet Fountain Housing with water only until the water
reaches the fill level in the Bowl.
7. Fill Reservoir with water.
8. Check the Reservoir Cap to make sure the black O-ring is in place, then screw the
Reservoir Cap onto the Reservoir.
fig. 1 fig. 2
pUmp