Petromax kx50-seat-b, User Manual

Page: 6 / 12

6
DE
EN
FR
Before the first use of the Seat Cushion with the Petromax Cool Box
Just a few tricks are needed before the first use of the Seat Cushion. Observe the following steps to
attach the Seat Cushion safely and firmly to the lid of the Petromax Cool Box:
1. Clean the four depressions that have been factory embedded into the lid of the Cool Box (above
the carry handles, always two per side).
2. Screw on the included counter pieces of the press studs to the depressions in the lid, any pre-drilling
or puncturing is not necessary. Make sure that you choose the position marked with a dot within
the depressions.
3. Fasten the counter pieces by hand for not to crush or otherwise damage the rubber seals.
4. Place the Seat Cushion (mesh fabric facing downwards) on the Cool Box, position flush and press
lightly one-by-one each of the four loops with press stud on the screwed-on counter pieces.
The press stud system is now installed and your Seat Cushion ready for use. For removal of your Seat
Cushion from the lid of your Petromax Cool Box the four cushion loops with press studs should be
pulled off sideways one-by-one and away from the lid. In case you do not want to use your Seat Cushion
occasionally the counter pieces remain on the lid.
Cleaning and care
Only clean the Seat Cushion by hand. You can remove slight dirt with a soft clothes brush. In case the
Seat Cushion is heavily soiled after one of your outdoor adventures you can wipe it with a moist cloth
and some detergent. When wet, the Seat Cushion should be air-dried well in a warm, well ventilated
place out of direct sunlight. Store your Seat Cushion in a dry, protected place and provide for enough
ventilation.
Technical Details
Model kx25-seat-b kx50-seat-b
Outer material (upper side) ripstop fabric (600D) ripstop fabric (600D)
Outer material (bottom side) non-slip mesh fabric non-slip mesh fabric
Material (inside)
foam foam
Dimensions (H x W x D) 5.5 x 56 x 38.5 cm 5.5 x 66 x 46.5 cm
Weight 487 g 995 g