Peter Lynn Twinskin, User Manual

Page: 7 / 20

PUTTING IN THE STICKS
REMOVING THE STICKS
TIPS REGARDING COMPACT STICKS
Make sure all the inner connectors
of the sticks are free of sand, snow or
any other debris. Assemble the sticks. Slide the stick into the pocket. Make sure the stick slides in all the
way, so the endcap sits in between the
webbing at the top of the pocket. Close the Velcro at the bottom to
secure the stick.
Open up the double Velcro seal at the
bottom of the pocket. Push the sticks out from the top, by
grabbing the pocket in the middle
and pushing the top down. Slide the stick out all the way and fold
it down. Place the sticks in the pocket at the
back of the backpack.
• Make sure the inner connectors of the sticks are free of sand, snow or any
other debris before assembling the sticks.
• Regularly clean the compact sticks with tap water.
To start your kite you need to follow these six steps:
Step 1. Finding the right location to launch your kite.
Step 2. Placing the kite on the beach ready to
Step 3. Setting up your bar and lines.
Step 4. Checking your safety systems.
Step 5. Preparing for launch.
Step 6. Launching the kite.
Find a spot to setup, away from airports, powerlines, trees and buildings. When
launching, the area should be free of kiteflyers or other people. Also make sure
there are no sharp objects on the ground, to prevent any damage to your kite.
Roll the kite out and put in the sticks if not already done so. Place one tip on
the ground with the lower skin upwards, and let the rest
in the wind. Fold a
so as many cells as possible can inflate in the upwind tip.
Open the zipper on the upwind tip, and make sure it stands open so the
air can in. Make sure both the zipper and the other zipper
are closed. While the kite is being pre-inflated you can start to get your flying
lines ready to be attached to the kite.
STARTING OFF
STEP 1. FINDING THE RIGHT LOCATION TO LAUNCH YOUR KITE
STEP 2. PLACING THE KITE ON THE BEACH READY TO PRE-INFLATE