ROADSTER Pet Stroller
PG8600
BACK WHEEL ASSEMBLY AND INSTRUCTIONS
2. Take rear wheels (on axel with brakes) and
lock them into the 2" posts by placing leg tube
over the posts and pressing down until they
click (shown in Figure D). Pull up to make
sure wheels are locked.
3. Place stroller so wheels are on the ground and
back wheels are facing you (shown in Figure E).
Note: To remove back wheels, push the
lock/release button and pull wheel off.
Figure D
4. Lift right and left side of stroller up. Shown
in Figure F. Secure the support bar that goes
from the left and latches down on the right
side (shown in Figure F).
Figure E
Figure F
5. To install the handle, place handle ends into the
handle-locking mechanisms on each side of the
stroller. Then, push down until you hear a click and
the velco buttons pop out on each side. From here,
you can choose desired height level (1 or 2). Pull up
on handle to make sure it is securely locked. This is
shown in Figure G.
Handle-Locking Mechanisms
4
Figure G
