4.
Install PERRIN Wing Risers Blocks to each side and carefully set wing on top of them.
5.
Set steel retaining clips over holes and install (1) supplied M6 bolt with washer onto each side to secure wing for next step.
6.
Apply supplied thread locking compound onto thread of both remaining bolts. Place bolts into remaining holes.
7.
Remove bolts that were installed without thread locking compound and apply thread locking compound to these and reinstall.
8.
Tighten bolts to secure wing to car making sure to line up PERRIN Wing Riser Block with base on car. Tighten bolts to 8ft-lbs.
9.
Reinstall plastic caps onto top of wing.
10.
Remove caps and check for tightness after 2 days of driving, then again after 2 weeks.
Questions, Comments and Suggestions Contact:
Visit Our Website for Instant Chat Options at
Call Our Tech Team at 503-693-1702
