9
HALL LAG
HALL SML
STADIUM
c
Press the “UP” or DOWN” button on
the remote to select one of the DSP
surround modes.
d
Press the “ENTER” button on the
remote handset to complete the
DSP surround mode selection.
11
AM/FM, TUNING +/-, PRESET
+/_,AM/FM, PTY
These buttons are not functional for
the AVP1
12
UP, DOWN, ENTER, + and –
These 5 buttons are used for
selection of some extra functions
such as CENTRE and REAR
CHANNEL TIME DELAY, DSP
SURROUND MODE and SLEEP
ON/OFF functions from the remote
handset. These buttons are used in
conjunction with the ON SCREEN
DISPLAY (OSD).
a CENTRE and REAR CHANNEL
TIME DELAY: This is only available
for Dolby Digital and Dolby Pro
Logic surround mode.
•
Press UP button to select one
function of CENTRE DELAY,
REAR DELAY or SLEEP.
•
Press + or – button to adjust the
delay time for the channel
selected.
b SLEEP: It is a function of the AVP1
to set SLEEP ON or OFF
•
Press UP button to select SLEEP
function
•
Press ENTER to set SLEEP ON
or OFF
The Remote control uses 2 internal "AAA"
size batteries and may be changed by
removing the plastic panel forward out of the
remote base
ON SCREEN DISPLAY (OSD)
The AVP1 is equipped with OSD, which
functions when any control is applied
Note: OSD does not function when using S
VHS output connections
GETTING STARTED
Having connected all the individual
components to your AVP1 we would
recommend you set up the system as
follows
1
With the master level set at a
reasonably low level set the size and
number of speakers being used in the
system using the speaker mode buttons on
the remote
2
Engage the test function and set the
individual balance of each channel using the
channel and level + / - buttons for each
analog and digital input in use - turn off the
test mode
3
Using a Dolby Digital / DTS and / or
Prologic source, set the rear and centre
delay times for the surround mode being
used on each input. With the remote
UP/DOWN buttons and OSD set up the
DELAY TIME for the centre and rear
channels.
4 At low levels, ensure the system is
operating correctly and that each input is set
for the correct mode and level
NOTE: Always ensure the AVP1 is
disconnected from the mains supply
before making any connections or
alterations.
INSTALLATION AND OPERATION
PRECAUTIONS
-
Leave the top and bottom of the AVP1
clear at all times allowing adequate
airflow around the sides of the unit. Do
not site this unit directly on carpet or
other soft surfaces. Do not place
auxiliary equipment directly on top of the
AVP1.
-
Always operate in a horizontal position.
- Install away from excessive heat and
moisture. Do not allow the ambient
temperature around the AVP1 to exceed
40º Celsius (105º Fahrenheit.)
-
Check the mains/line voltage stated on
the rear panel of your. AVP1 Supply
voltage must be /- 5% of the
stated voltage.
-
Connect all your hi-fi equipment to the
same mains/line source to avoid
possible earthing problems.
-
Do not change the fuse to any type or
rating other than that indicated on the
rear panel or owners manual.