Permaquip Sleeper Squarer, Quick Manual

Page: 6 / 61

MAN/M/O/197-03
6
Always use the correct, clean oil, as defined in the technical
specification. The portable Sleeper Squarer has been filled and tested
with clean, new hydraulic oil to this specification. It must be properly
maintained and not contain contaminated oil. No liability will be accepted
for failure or malfunction of the equipment if this condition is not met.
Always use the correct, clean filtered fuel, as defined in the technical
specification. The portable Sleeper Squarer has been tested with clean,
new fuel to this specification and then drained. Contaminated fuel must
not be used. When fuel is left in the engine it should be ran every for 5
minutes every 4 to 6 weeks. No liability will be accepted for failure or
malfunction of the equipment if this condition is not met.
Keep all components away from extreme temperatures.
The portable Sleeper Squarer is not obstructionless, so adequate
protection must be used.
The portable Sleeper Squarer can affect track stability. Refer to the
railway infrastructure for guidance.
Do not use the Hydraulic Hoses to move the portable Sleeper Squarer.
Do not allow the hoses to kink, twist, curl or bend. Do not allow the
hoses to come into contact with corrosive substances such as paint, oil,
etc. Refer to Permaquip for further advice.
Do not use the portable Sleeper Squarer for any other purpose than as
described in the introduction.
Do not drag the portable Sleeper Squarer along the ballast.
Do not hold off the Brake Handle using mechanical means.
Stopping distances will greatly increase by icy or wet conditions;
gradients; an increase in load; an increase in speed.