Attach the pillar to the base.
Attach the pillar ② to the base ① using C and E .
Remember to place the plastic plate B in between the
pillar ② and base ①.
Next, tighten the screws using the hex key G .
Use 2 sets of
D
and hex key
F
to tighten the right
part ③ and ⑥ together, fasten four screws again to
make sure they are tight.
Attach the parts ③ and ⑥
to ②
Put the 2 plates ③ next
to each other on top of
the pillar in line with the
screw holes.
Next, place the covering
plate ⑥ with the LOGO
facing upwards on top of
the plates ③ in line with
the screw holes.
Use 2 sets of
D
and hex
key
F
to tighten the left
part ③ and ⑥ together.
Screw the four screws
D
to the pillar ② using the hex key
F
.
Before mounting the TV, adjust the pillar to the desired height.
6
6
6
Place foot pads
A
on the bottom of the base ① in the corners.
M4mm
Note:The 3 screws to connect the
base ① and the pillar ② MUST be
firmly tightened.
Height adjustment
according to the size
of your TV.
Select TV Screws Diameter
Hand thread TV screws into
the threaded inserts on the
back of your TV to
determine which screw
diameter(M6 or M8)to use.
Select TV Screw diameter.
Select TV Screw Length
If your TV has a flat back, use the shorter TV screws.
Spacers and longer TV screws are supplied to accommodate:
irregular/round back TVs, TVs with inset munting holes,
Extra space needed for cables
FLAT BACK ROUND BACK INSET HOLES CABLES
CAUTLON:
Verify adequate thread
engagement with the screw or
screw/spacer combination.
-Too short will not hold the TV.
-Too long will damage the TV.
Too short
Correct
Too Long
Summary of Contents for PSTVS02
Page 1: ......
