7
ø10mm
70mm
Drill 4 pilot holes using a 10mm diameter
drill bit. Make sure the depth is not less
than 70mm. Never drill into the mortar
between blocks.
5B-1
5B-2
5B-3
Position the wall plate at your desired
height, level the wall plate and mark the
pilot hole locations.
A1
A2
Use the hammer to knock
anchors [A3] into the wall.
Be sure the anchors [A3]
are seated flush with the
concrete surface.
A3
Install the wall plate using lag bolts [A1], washers [A2]
and anchors [A3]. Tighten the lag bolts [A1] only until
the washers [A2] are pulled firmly against the wall plate.
DO NOT over-tighten the lag bolts [A1].
