16 - 24 in.
16 in.
(406 mm)
2-1
2-2
2-4
01
01
01
02
03
Adjust the tilting angle with the Allen wrench for both and .
Locate your
stud. Verify
and mark
the center
of the stud
by fi
nding the
stud edges using
an awl, a thin
nail, or an edge-
to-edge stud fi
nder.
Position
the wall
plate at your
desired
height and line
up the holes with
your stud center
line. Level the wall plate
and mark the holes.
01
Install the
wall plate
assembly using lag
bolts and
washer .
A
B
B
Tighten
the lag bolts
A
only until it against the
wall plate.
STEP 3
Tighten Nuts
STEP 4
Hang TV
STEP 5
Secure TV
Pull the strap down and push the
TV to secure the TV brackets
and to the wall plate
CAUTION:
Avoid potential personal injuries and property damage!
●
Drywall covering the wall must not exceed 5/8 in. (16 mm)
●
Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 1½ x 3½ in. (38 x 89 mm)
CAUTION:
Avoid potential personal injury or property damage! All lag bolts
A
MUST BE firmly tightened to prevent
unwanted movement of the wall plate assembly.
CAUTION:
Ensure the wall plate assembly is securely fastened to the wall before continuing on to the next step.
02
03
C
C
C
Perle electronics hardware (Hongkong) Co., Limited (collectively, “Perle electronics hardware”), intend to make this manual accurate and complete. However, Perle electronics hardware makes no claim that the informations contained harein covers all details, conditions, or variations.
Nor does it provide for every possible contingency in connection with the installation or use of this product.
The information contained in this document is subject to change without notice or obligation of any kind.
Perle electronics hardware makes no representation of warranty, expressed or implied, regarding the information contained harein . perle electronics hardware assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
c 2016 Perle electronics hardware. All right reserved.
Perlegear is a Perle electronics hardware brand. Perlegear and the Perlegear logo are trademarks of Perle electronics hardware.
Made in China.
Perle electronics hardware Clobal Headquarters • Room 1505 Building 17/F NO.3
，
Kwai Cheong Rd Nt
，
HongKong •
Any questions please contact : [email protected]
2-3
Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT
: Be sure to drill into the center of the stud.
IMPORTANT
: Pilot holes must be drilled to a depth of in.
(70
mm).
7/32 in.
(5.5 mm)
in. (70 mm)
STEP 2
Wood Stud
A
02
02
03
03
02
Tighten
Ajust this nut
Loosen
03
