Perle 10/100/1000 Media Converter Module – Installation Guide
10
Installing or Replacing Media Converter
Modules
Caution: Observe electrostatic discharge precautions
when installing the Media Converter Module(s) into the
Chassis. Failure to observe this caution could result in
damage to the Media Converter Module(s) and /or chassis.
The Perle Media Converter Modules can be installed in any
available slot and in any order within the chassis.
Installing or Replacing a Media Converter Module
1. Remove the Media Converter Module from its packaging.
2. Using a cross-head screwdriver, remove the screw
holding the face plate to the Chassis to reveal the slot
opening.
3. Set the jumpers and DIP switches on the Media Converter
Module to the desired operating mode.
4. Locate the top and bottom alignment guides inside the
Chassis.
5. Using the module alignment guides gently slide the
module into the slot until it becomes flush with the front of
the Chassis. Light pressure may be needed to seat the
module. Do not force the module as you might cause
some damage. If there is resistance, remove the module,
check the module connector for damaged or incorrectly
aligned pins, if there is no damage, retry module insertion.
6. Tighten the captive retainer screw to ensure the Media
Converter Module is locked in place.
