i08308367
Note:
The
wait
to
disconnect
lamp
will
not
be
checked
at
key
on.
Monitoring
System
(Engine
Indicators)
Engine
Indicator
Lamps
Note:
When in operation the amber warning lamp
has three states, solid, flashing, and fast flashing.
The sequence is to give a visual indication of the
importance of the warning. Some application can
have an audible warning installed.
Ensure that the engine maintenance is carried out at
the correct intervals. A lack of maintenance can
result in illumination of the warning lamp. For the
correct intervals of maintenance, refer to the
Operation and Maintenance Manual, “Maintenance
Interval Schedule”.
Table 2
Indicator Lamp Table
Warning
Lamp
Shutdown
Action Indi-
cator Lamp
Lamp State
Description of the Indication
Engine Status
On
On
Lamp Check
When the keyswitch is moved to the ON po-
sition, the lamps come on for 2 seconds and
the lamps will then go off.
The keyswitch is in the ON position but the en-
gine has not yet been cranked.
If any of the indicators will not illuminate during indicator check, the fault must be investigated immediately
If any Indicators stay illuminated or flash, the fault must be investigated immediately.
Off
Off
No Faults
With the engine in operation, there are no
active warnings, diagnostic codes, or event
codes.
The engine is operating with no detected
faults.
On Solid
Off
Warning
Level 1 warning
The engine is operating normally but there is
one or more faults with the electronic manage-
ment system for the engine.
As soon as possible the fault should be investigated.
Flashing
Off
Warning
Level 2 warning
The engine continues to be operated, but the
level of importance of the warning has
increased.
Depending on the particular fault and the se-
verity the engine may be de-rated.
The engine could be damaged if continued to
be operated.
(continued)
34
M0125147