Illustration 55
g06304508
Typical example
8.
Remove the filter element (4). Clean the filter bowl.
Install the New Filter Element
Illustration 56
g06304524
Typical example
1.
After repositioning the self-venting drain up, locate
the thread in the new filter element (6) onto the
thread (7). Spin on the filter element and tighten
the drain valve (2) securely.
2.
Lubricate the lip (Position (X) ) with clean engine
oil. Do NOT fill the bowl with fuel before the
assembly is installed.
Note:
Do not use a tool to install the filter assembly.
3.
Align the filter bowl (5) to the assembly. Rotate the
filter bowl (5) clockwise by hand. Rotate the filter
bowl (5) until there is no visible gap between the
element and the filter bowl and the assembly.
4.
Remove the container and dispose of the fuel in a
safe place.
5.
Install the wiring harness to connection (3).
6.
The secondary filter element (if equipped) must be
replaced at the same time as the primary filter
element. Refer to the Operation and Maintenance
Manual, “Fuel System Secondary Filter - Replace”.
i08158885
Fuel
System
Primary
Filter/
Water
Separator
-
Drain
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
NOTICE
Ensure that the engine is stopped before any servic-
ing or repair is performed.
NOTICE
The water separator is under suction during normal
engine operation. Ensure that the drain valve is tight-
ened securely to help prevent air from entering the
fuel system.
Drain Procedure
1.
Place a suitable container under the water
separator to catch any fluid that might spill. Clean
up any spilled fluid.
M0108133-04
95