The rotating shaft hand crush hazard label (7) is on
the cover of the crankshaft vibration damper.
i08369706
Additional
Messages
Illustration 10
g06249496
Typical example
The labels will be installed on the engine oil cooler. A
special starting procedure may be required. Refer to
this Operation and Maintenance Manual, Before
Starting Engine for the correct procedure.
Illustration 11
g00955999
Typical example
The labels will be installed on coolant pipe next to the
oil filler. Refer to this Operation and Maintenance
Manual, Fluid Recommendations (General Coolant
Information) for information.
i08344585
General
Hazard
Information
Illustration 12
g00104545
Attach a
“
Do Not Operate
”
warning tag or a similar
warning tag to the start switch or to the controls
before the engine is serviced or before the engine is
repaired. Attach the warning tags to the engine and
to each operator control station. When appropriate,
disconnect the starting controls.
Do not allow unauthorized personnel on the engine,
or around the engine when the engine is being
serviced.
• Tampering with the engine installation or
tampering with the OEM supplied wiring can be
dangerous. Personal injury, death and/or engine
damage could result.
• Vent the engine exhaust to the outside when the
engine is operated in an enclosed area.
• Wear a hard hat, protective glasses, and other
protective equipment, as required.
• When working around an engine, the engine must
not be in operation. You may only be near a
running engine to carry out maintenance
procedures that require the engine to be in
operation.
• Do not wear loose clothing or jewelry that can
snag on controls or on other parts of the engine.
• Ensure that all protective guards and all covers
are secured in place on the engine.
• Never put maintenance fluids into glass
containers. Glass containers can break.
• Use all cleaning solutions with care.
• Report all necessary repairs.
10
M0122761