Perkins 1206E-E70TTA, Operation And Maintenance Manual, Page: 32 / 142

i07434782
Operation Section
Lifting and Storage
Product Lifting
(Engine)
Illustration 29 g01097527
NOTICE
Never bend the eyebolts and the brackets. Only load
the eyebolts and the brackets under tension. Re-
member that the capacity of an eyebolt is less as the
angle between the supporting members and the ob-
ject becomes less than 90 degrees.
When it is necessary to remove a component at an
angle, only use a link bracket that is properly rated for
the weight.
NOTICE
Always inspect lifting eyebolts and all other lifting
equipment for damage before performing any lifting.
Never Bend the eyebolts and the brackets. Never
perform product lifting if the components are
damaged.
Use a hoist to remove heavy components. Use an
adjustable lifting beam to lift the engine. All
supporting members (chains and cables) should be
parallel to each other. The chains and cables should
be perpendicular to the top of the object that is being
lifted.
Some removals require lifting the fixtures in order to
obtain correct balance and safety.
To remove the engine ONLY, use the lifting eyes that
are on the engine.
Lifting eyes are designed and installed for specific
engine arrangements. Alterations to the lifting eyes
and/or the engine make the lifting eyes and the lifting
fixtures obsolete. If alterations are made, ensure that
correct lifting devices are provided. Consult your
Perkins dealer or your Perkins distributor for
information regarding fixtures for correct engine
lifting.
i07434786
Product Lifting
(Clean Emission Module)
NOTICE
Never bend the eyebolts and the brackets. Only load
the eyebolts and the brackets under tension. Re-
member that the capacity of an eyebolt is less as the
angle between the supporting members and the ob-
ject becomes less than 90 degrees.
When it is necessary to remove a component at an
angle, only use a link bracket that is properly rated for
the weight.
NOTICE
Always inspect lifting eyebolts and all other lifting
equipment for damage before performing any lifting.
Never Bend the eyebolts and the brackets. Never
perform product lifting if the components are
damaged.
Use a hoist to remove heavy components. Use an
adjustable lifting beam to lift the Clean Emission
Module. All supporting members (chains and cables)
should be parallel to each other. The chains and
cables should be perpendicular to the top of the
object that is being lifted.
Some removals may require lifting the fixtures to
obtain proper balance and safety.
32 SEBU8601-04
Operation Section
Lifting and Storage