Illustration 80
g01348394
Adjustment of the cover will change the clearance
(gap) between the edge of the cover and the tip of
the fan blade. Ensure that the cover is centralized to
the fan.
The clearance (A) must be 11 ± 2 mm
(0.43307 ± 0.07874 inch).
i05774864
Fuel
System
-
Prime
Note:
Refer
to
Systems
Operation,
Testing,
and
Adjusting,
“Cleanliness
of
Fuel
System
Components”
for
detailed
information
on
the
standards
of
cleanliness
that
must
be
observed
during
ALL
work
on
the
fuel
system.
Ensure
that
all
adjustments
and
repairs
are
performed
by
authorized
personnel
that
have
had
the
correct
training.
NOTICE
Do not crank the engine continuously for more than
30 seconds. Allow the starting motor to cool for two
minutes before cranking the engine again.
If air enters the fuel system, the air must be purged
from the fuel system before the engine can be
started. Air can enter the fuel system when the
following events occur:
• The fuel tank is empty or the fuel tank has been
partially drained.
• The low-pressure fuel lines are disconnected.
• A leak exists in the low-pressure fuel system.
• The fuel filter has been replaced.
Use the following procedures in order to remove air
from the fuel system:
1.
Ensure that the fuel system is in working order.
Check that the fuel supply valve (if equipped) is in
the
“
ON
”
position.
SEBU8601-04
117