i08258438
Before
Starting
Engine
NOTICE
For initial start-up of a new or rebuilt engine, and for
start-up of an engine that has been serviced, make
provision to shut the engine off should an overspeed
occur. This may be accomplished by shutting off the
air and/or fuel supply to the engine.
Engine exhaust contains products of combustion
which may be harmful to your health. Always
start and operate the engine in a well ventilated
area and, if in an enclosed area, vent the exhaust
to the outside.
Inspect the engine for potential hazards.
Do not start the engine if there is a
“
DO NOT
OPERATE
”
warning tag or similar warning tag
attached to the start switch. Do not move any of the
controls if there is a
“
DO NOT OPERATE
”
warning
tag or similar warning tag attached to the controls.
Before starting the engine, ensure that no one is on,
underneath, or close to the engine. Ensure that the
area is free of personnel.
If equipped, ensure that the lighting system for the
engine is suitable for the conditions. Ensure that all
lights work properly, if equipped.
All protective guards and all protective covers must
be installed if the engine must be started to perform
service procedures. To help prevent an accident that
is caused by parts in rotation, work around the parts
carefully.
Do not bypass the automatic shutoff circuits. Do not
disable the automatic shutoff circuits. The circuits are
provided to help prevent personal injury. The circuits
are also provided to help prevent engine damage.
See the Service Manual for repairs and for
adjustments.
i08185623
Engine
Starting
Do not use aerosol types of starting aids such as
ether. Such use could result in an explosion and
personal injury.
If a warning tag is attached to the engine start switch,
or to the controls DO NOT start the engine or move
the controls. Consult with the person that attached
the warning tag before the engine is started.
All protective guards and all protective covers must
be installed if the engine must be started to perform
service procedures. To help prevent an accident that
is caused by parts in rotation, work around the parts
carefully.
Start the engine from the operator's compartment or
from the engine start switch.
Always start the engine according to the procedure
described in the Operation and Maintenance Manual,
“Engine Starting” topic in the Operation Section.
Knowing the correct procedure will help to prevent
major damage to the engine components. Knowing
the procedure will also help to prevent personal
injury.
To ensure that the jacket water heater (if equipped)
and/or the lube oil heater (if equipped) is working
correctly, check the water temperature gauge. Also,
check the oil temperature gauge during the heater
operation.
Engine exhaust contains products of combustion
which can be harmful to health. Always start the
engine and operate the engine in a well ventilated
area. If the engine is started in an enclosed area,
vent the engine exhaust to the outside.
Note:
The engine is equipped with a device for cold
starting. If the engine will be operated in very cold
conditions, an extra cold starting aid may be
required. Normally, the engine will be equipped with
the correct type of starting aid for the region of
operation.
These engines are equipped with a glow plug starting
aid in each cylinder which heats the intake air to
improve starting. Some Perkins engines may have a
cold starting system that is controlled by the ECM
which allows a controlled flow of ether into the
engine. The ECM will disconnect the glow plugs
before the ether is introduced. This system would be
installed at the factory.
i02234873
Engine
Stopping
Stop
the
engine
according
to
the
procedure
in
the
Operation
and
Maintenance
Manual,
“Engine
Stopping
(Operation
Section)”
in
order
to
avoid
overheating
of
the
engine
and
accelerated
wear
of
the
engine
components.
SEBU9063-07
19