i07091086
Engine
Air
Cleaner
Element
-
Replace
NOTICE
Never run the engine without an air cleaner element
installed. Never run the engine with a damaged air
cleaner element. Do not use air cleaner elements
with damaged pleats, gaskets or seals. Dirt entering
the engine causes premature wear and damage to
engine components. Air cleaner elements help to pre-
vent airborne debris from entering the air inlet.
NOTICE
Never service the air cleaner element with the engine
running since this will allow dirt to enter the engine.
Servicing the Air Cleaner Elements
Note:
The air filter system may not have been
provided by Perkins. The procedure that follows is for
a typical air filter system. Refer to the OEM
information for the correct procedure.
If the air cleaner element becomes plugged, the air
can split the material of the air cleaner element.
Unfiltered air will drastically accelerate internal
engine wear. Refer to the OEM information for the
correct air cleaner elements for your application.
• Check the precleaner (if equipped) and the dust
bowl daily for accumulation of dirt and debris.
Remove any dirt and debris, as needed.
• Operating in dirty conditions may require more
frequent service of the air cleaner element.
• The air cleaner element should be replaced at
least one time per year.
Replace the dirty air cleaner elements with clean air
cleaner elements. Before installation, the new air
cleaner elements should be thoroughly checked for
tears and/or holes in the filter material. Inspect the
gasket or the seal of the air cleaner element for
damage. Maintain a supply of suitable air cleaner
elements for replacement purposes.
Air Cleaners
Some application can have dual elements. The dual
air cleaner contains a primary air cleaner element
and a secondary air cleaner element. Both element
must be replaced at the same time.
Do not replace the air cleaner filter elements in a dirty
environment, as dirt can enter the air system when
the elements are removed.
Illustration 29
g06217098
Typical example
1.
Ensure that the outer body of the air cleaner to be
serviced is clean and free from dirt.
2.
Inspect the top cover (1) and if necessary remove
top cover to clean cover. Ensure that dirt cannot
enter the air cleaner system with top cover
removed. If necessary, clean top cover and install.
3.
Remove end cover (4) from air cleaner body (2). If
necessary, clean end cover and ensure that the
valve (5) is clean and free from dirt. Check the
valve (5) for wear or damage, replace if necessary.
4.
Remove primary air filter element (3) and if
equipped, remove the secondary air filter element
(Not Shown). Discard all old air filter elements.
5.
If equipped, install new secondary air filter element
(Not Shown) and install new primary air filter
element (3).
58
M0106585