Spin-on filter
Turn the valves for the fuel lines (if equipped) to the
OFF position before performing this maintenance.
Place a tray under the fuel filter in order to catch any
fuel that might spill. Clean up any spilled fuel
immediately.
Illustration 40
g01440509
Typical example
(1) Fuel priming pump
(2) Spin-on filter
(3) Drain
1.
Clean the outside of the fuel filter assembly. Open
the fuel drain (3) and drain the fuel into a suitable
container.
2.
Use a suitable tool in order to remove the spin-on
filter (2) from the fuel priming pump (1).
3.
Ensure that the fuel drain (3) on the new spin-on
filter is closed.
Illustration 41
g01440510
Typical example
4.
Lubricate the sealing ring (4) with clean fuel oil.
5.
Install the spin-on filter (2) into the top of the fuel
priming pump (1).
6.
Tighten the spin-on filter by hand until the sealing
ring contacts the fuel priming pump. Rotate the
spin-on filter through 90 degrees.
7.
Prime the fuel system. Refer to Operation and
Maintenance Manual, “Fuel System - Prime”.
i02813964
Hoses
and
Clamps
-
Inspect/
Replace
Inspect
all
hoses
for
leaks
that
are
caused
by
the
following
conditions:
• Cracking
• Softness
• Loose clamps
Replace hoses that are cracked or soft. Tighten any
loose clamps.
66
SEBU8352-02