PerkinElmer Frontier IR, User Manual

Page: 40 / 104

40 . Frontier IR Dual-Range Systems User's Guide
Connecting up the Spectrometer
Connecting to the PC
NOTE: To control your instrument from a PC, use the crossover cable supplied.
To control your instrument over your network, use a standard Ethernet cable (not
supplied).
1. Plug one end of the cable into the connector port on the right-hand side of the
instrument (Figure 12).
Figure 12 PC Connection port
2. Plug the other end of the cable into the network connection on your PC (if you are using
the crossover cable) or network hub (if you are using a standard Ethernet cable).
Connector details
Description Connector
Type
Voltage Maximum
Current
10/100 Base-T Ethernet connector. This is the
standard interface between the PC and the
instrument, or between a Local Area Network (LAN)
and the instrument. If connecting directly from the
PC to the instrument use the Category 5 UTP
Cross-Over cable supplied. If you are connecting to
your network, use a standard Ethernet cable.
DO NOT USE THE CROSS-OVER CABLE TO
CONNECT TO YOUR NETWORK.
Ethernet <5 V <100 mA
PC or network
connection port