5
2.1a Harness PXHGMT: (No XM)
1. Carefully remove the radio from the dash of the vehicle.
2. Plug the male 12-pin connector of the PXHGMT harness into the female
12-pin port on the back of the radio. Next connect the factory male 12-pin
connector into the female 12-pin connector on the PXHGMT harness.
If
the vehicle has an external 6 disc CD-Changer, plug the female 24-pin end
of the PXHGMTCD CD changer retention harness (sold separately) into
the male 24-pin connector on the PXHGMTX.
3. Make all necessary power connections.
YELLOW: Connect to 12V+ constant power.
BLACK: Connect to the vehicle’s Chassis Ground.
4. Optional Connections:
RED: Retains Accessory Power (RAP). Provides 12V(+) accessory power
after the vehicle is turned off up to 10 minutes, or until the drivers door is
open.
RED/WHITE: Non-functional wire; no connection is necessary.
Note: Insulate all wires that are on the PXDP3 harness that are not used
for installation
5. Connect the 8-pin connector on the iPod docking cable to the PXDP-
GMT interface.
(DO NOT CONNECT IPOD AT THIS TIME, WAIT UNTIL
INITIALIZATION IS COMPLETE, SEE SECTION 2.2 FOR DETAILS)
6. Plug the male 24-pin connector of the PXHGMT harness into the PXD-
PGMT interface.
Part
#
PXHGMT
Male Plug
12 Pin Female Plug
FACTORY 12 PIN HARNESS
PXHGMT
Harness
12 Pin Male Plug
RCA CABLE
iPod PLUG
& CABLE
32 Pin Power
Audio Harness
PXDPGMT
OPTIONAL
AUDIO
SOURCE
FACTORY RADIO
iPod
(+) 12V Constat Power
(-) Chassis Ground
Red Wire From T-harness Optional
ACC +12V OUTPUT works with RAP
( Retained Accessory Power)
PHXGMTCD Harness
If Equipped with
W/CD Changer
