➍
Connect the power.
Connect the power cable to the back of the SR-15 chassis, and then con-
nect the other end of the power cable to your local power source.
NOTE:
The SR-15’s power usage is 50 Watts Max or 170 BTU/hr.
STOP:
If you have PeriScope CMS 5.0 (or later), you can stop here and
use auto-deployment to configure the device automatically.
➎
Configure SR-15 Network Settings.
To configure the network settings for the SR-15, you connect an
ANSI compatible terminal to the Sequence Reducer’s serial port
and use a terminal emulation program (e.g., HyperTerminal) to log
in to the Sequence Reducer’s CLI.
Note the following serial port settings:
Baud Rate:
9600
, Data Bits:
8
, Parity:
NONE
, Stop Bits:
1
,
Flow Control:
NONE
, Smooth-Scroll:
DISABLED
5
•
Start the terminal emulation program, and choose to connect via the
serial port.
5
•
At the User name and Password prompts, type
admin
for the user name and
peribit
for the password.
5
•
Type an IP address, and then press
Enter
. Next, type the subnet mask for the network, and then press
Enter
. Finally, type
the default gateway for this device, and then press
Enter
.
5
•
To save the configuration file, type “save-config”. Type “y” to confirm saving the running configuration as the startup con-
figuration. (You can safely bypass the other configuration questions at this time.)
NOTE:
By default, the Sequence Reducer’s 10/100 interfaces are set to auto-negotiate the speed and duplex mode. However,
you may want to set the interface speed and duplex mode for the Sequence Reducer. The SR-15’s LOCAL port settings
should match the interface settings of the switch, and the REMOTE port settings should match the interface settings of the
router. For more information, refer to the Sequence Reducer/Sequence Mirror Operator’s Guide.
➏
Check the LEDs next to the 10/100 Ethernet ports.
5
•
If the LINK LEDs light, the device is properly connected.
5
•
The 100M LEDs indicate 100 Mb connectivity.
5
•
Press Bypass Disable only if you want to block traffic during a
power failure (used in high-availability environments).
After checking the LEDs, you should verify connectivity between the
devices on both sides of the SR-15 again (as described in Step 3).
100/240V 50-60 ~ 1/.5A
Model No. SR-15 PERIBIT NETWORKS
||||||||||||||||||||||||||||||||||||||||||||||||||
S/N 0123456789
CONSOLE
100/240V 50-60 ~ 1/.5A
BYPASS
DISABLE
Model No. SR-15 PERIBIT NETWORKS
||||||||||||||||||||||||||||||||||||||||||||||||||
S/N 0123456789
CONSOLE
LOCAL REMOTE
LINK
LINK
100/10
100/10
LINK
LINK
100/10
100/10
LOCAL
REMOTE
BYPASS
DISABLE
SR-15
QUICK START
