P a g e
|
6
SECTION 4 - MAIN RUNNERS
1.
Notice that the marks on the long sides of the top plate
(a line with an X) are spaced the same on both sides. Set
a 2x6 runner up on the frame at one end. Position the
first runner over the X, with the edge lined up with the
line marked on the top plate.
2.
Next, adjust the runner to get the same overhang
measurements on both ends of the runner. Remember
the measurement, as this will be used on the rest of the
runners making sure that the ends are aligned equally.
3.
When the runner is in the correct position, attach by
screwing a 2 ½" white headed screw from the
underside of the top plate up into the runner. Predrill
a pilot hole, at least on the outside runners. Angle the
screw as shown at right, being sure to hold down on
the runner as you drive the screw in to keep it from
moving. Do this for the other ends of the runners.
4.
Set the next runner over the markings and secure in the
same manner, making sure that the overhang is the
same as in the previous runner. Continue this with
each of the runners.
When all of the runners are in place and secured with 2 ½"
white head screws. Run a screw from the inside of the
pergola, up through the exposed top plate and into the runner
as done on the outside. Angle the screw outward slightly.
Summary of Contents for Serenity Vinyl Pergola Kit
Page 8: ......