19
PRACTICE CUTS USING THE
FREEHAND CUTTING GUIDE
Before attempting to work on an actual
project, take the time to make a few
practice cuts with your cut-out saw. Use
some scraps of material that are the same
material as will be used in your actual
project.
1. Draw a pattern similar to your first
project on a scrap piece of material.
2. Install the assist handle and the
freehand cutting guide as shown in
Fig. 1 & 2.
3. Install cutting bit in the collet as shown
in Fig. 3.
4. Adjust depth of freehand cutting guide
as shown in Fig. 7.
5. Set the speed control switch to the
appropriate speed.
6. Rest the edge of the cutting guide on
the workpiece with the bit at an angle
of about 45° (Fig. 8).
NOTE:
DO NOT
let the bit come into
contact with the workpiece until the power
switch is turned ON and the tool is up to
full speed.
WARNING:
Before turning the
power switch ON, make sure you are
holding the tool firmly with both hands.
Starting torque will cause the tool to
twist.
7. Turn the switch ON.
ASSEMBLY AND OPERATING
!
Fig. 8
Summary of Contents for 241-0968
Page 27: ...27 EXPLODED VIEW...
