2
SAFETY GUIDELINES / DEFINITIONS
UNPACKING AND INSPECTION
SPECIFICATIONS
Specifications are
subject to change
without notice.
Input Voltage .........................................................120V ~60hz
Rated Current ....................................................................3.2A
No-Load Speed .................................................... 0-3000 RPM
Chuck Capacity (MAX) ......................................................3/8"
WARNING: Read and understand this entire instruction manual before attempting to assemble, install, operate or
maintain this product. Failure to comply with the instructions may result in serious personal injury and/or property
damage!
The following signal words are used to emphasize safety warnings that must be followed when using this
product:
This instruction manual is intended for your benefit. Please read and follow the safety, installation, maintenance and
troubleshooting steps described within to ensure your safety and satisfaction. The contents of this instruction manual are
based upon the latest product information available at the time of publication. The manufacturer reserves the right to make
product changes at any time without notice.
DANGER Indicates an imminently hazardous
situation that, if not avoided, WILL result in death or
serious injury.
WARNING Indicates a potentially hazardous
situation that, if not avoided, COULD result in death
or serious injury.
CAUTION Indicates a potentially hazardous situation
that, if not avoided, MAY result in minor or moderate
injury.
NOTICE Indicates important information, which if not
followed, MAY cause damage to equipment.
After opening the carton, unpack your new product and related parts & accessories. Please inspect it carefully for
any damage that may have occurred during transit. Please check it against the photograph on carton.
WARNING: DO NOT operate this product if damaged during shipment, handling or misuse. Do not operate the
product until the parts have been replaced or the fault rectified. Failure to do so may result in serious personal
injury or property damage. All damaged parts must be repaired or replaced as needed prior to operating this
product. Check to see that all nuts, bolts and fittings are secure before putting this product into service.
Please have the serial number, model number, and date of purchase available for reference when calling.
IMPORTANT SAFETY INFORMATION
WARNING:
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE OPERATING THIS
PRODUCT. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE AND
WILL VOID WARRANTY.
1. Always use common sense and pay particular
attention to all the DANGER, WARNING,
CAUTION and NOTICE statements of this
manual. The safety instructions provided are
not intended to cover all possible conditions
and practices that may occur when operating,
maintaining and cleaning power tools.
2. Observe work area conditions. Do not use ma-
chines or power tools in damp or wet locations.
Don’t expose to rain. Keep work area well
lighted. Do not use electrically powered tools in
the presence of flammable gases or liquids. Do
not bring combustible materials near the tools.
Power tools create sparks, which may ignite
the dust or fumes. Keep work area clean and
well lit. Cluttered work areas invite accidents.
3. Use personal protective equipment. Wear
ANSI approved safety goggles. Protective
equipment such as dusk mask, non-skid safety
shoes, hard hat, heavy duty work gloves or
hearing protection used for appropriate condi-
tions will reduce personal injuries.
4. Keep bystanders, children and visitors away
while operating this product. Distractions can
cause you to lose control.
5. Stay alert. Watch what you are doing, and use
common sense when operating this product.
Do not use this product while tired or under
