5
WARNING: The voltage specifications on the rating plate must correspond with the supply
voltage.
This impact wrench is equipped with a rocker switch that switches the rotation from clockwise to
counter-clockwise easily, allowing fasteners to be broken loose. Pressing the lower part of the
switch causes the impact wrench to move clockwise. Pressing the upper part of the switch causes
the rotation to reverse.
OPERATION
WARNING: Always unplug the tool before changing accessories.
MAINTENANCE
The impact wrench will require lubrication after 30 continuous hours or 50 intermittent hours of use.
Contact an approved service center for lubrication services.
NOTICE: UNPLUG WRENCH BEFORE INSPECTING BRUSHES!
The brushes should pierdically inspected for repair. Unscrew the plastic caps located on the side
of the motor housing to reveal the spring and brush assembly. Keep brushes clean and freely
sliding. Symbols are inscribed on the brushes, and if it is worn down to the line closest to the
spring, replace immediately.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model. Accesso-
ries that may be suitable for one tool may become hazardous when used on another tool.
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets. If you
must use an extension cord, be sure that the gauge is large enough to carry the amount
of current necessary for your power tool. If not, your tool may experience a loss of power,
excessive voltage drop or overheating. The smaller the gauge number, the heavier the cord
(see table below).
