Installation Precautions
1. Unplug the cord reel before installing.
2. Install only according to these instructions. Improper Installation can create hazards.
3. Wear ANSI-approved safety goggles and heavy-duty work gloves during installation.
4. Keep Installation area clean and well lit.
5. Keep bystanders out of the area during installation.
6. Do not install when tired or when under the influence of alcohol, drugs or medication.
7. Install the Cord Reel properly before connecting to the power supply.
8. If mounted in an area that is not readily accessible, connect this Cord Reel to a switch-controlled outlet; then, if a malfunction
occurs, the Reel can be disconnected immediately.
9. Install out of reach of children.
10. Verify that installation surface has no hidden utility lines before drilling or driving screws.
Wall Mount Installation
1. Select location within 2 feet of an electrical outlet.
2. Use a stud finder to locate a stud and using the mounting bracket as template, mark the holes so they are centered
on the wall stud.
3. Attach the mounting bracket to the wall stud using the 2 wood screws.
4. Make sure the larger end of the teardrop opening in the brackets is on top.
CAUTION: DRYWALL WILL NOT HOLD THE WEIGHT OF THE REEL ASSEMBLY.
OPERATION
1. Plug into any 110-125V 60Hz polarized outlet. Be aware of the plug and insert properly.
2. Pull cord out to desired length. Notice a clicking noise when pulling the cord.
The cord will stay at the desired length during the clicking and rewind after a pull past the clicking noise.
3. Extended length when retracted can be achieved by sliding the rubber stop on the cord to the desired position.
4. To retract, pull cord out and guide cord slowly back into the reel.
CAUTION: Outlet is energized at all time. DO NOT OVERLOAD!
NOTE: Cord length is 40 feet long fully extended. DO NOT pull on cord after cord is fully extended.
CAUTION: DO NOT ALLOW THE CORD TO RETRACT BY ITSELF AS DAMAGE OR INJURY MAY OCCUR
FROM EXCESSIVE REWIND SPEED.
Remove dirt and grime as soon as it accumulates. Use a soft damp cloth and a mild soap if needed. Be sure not to get the electrical
plug wet. NEVER submerge any part of the cord reel in any solution to clean it.
DO NOT USE solvents such as gasoline, turpentine, etc. to clean unit. Keep reel cord clean to maintain smooth retraction. To clean,
simply pull cord to its full length and allow to retract through a dampened rag. Pull out full length again and allow to retract through
clean rag sprinkled with talcum powder.
DRY THOROUGHLY BEFORE PLUGGING BACK INTO OUTLET.
INSTALLATION
CAUTION: Read and understand Mounting instructions before attempting installation and use of this product.
WARNING: TO AVOID INJURY ALWAYS UNPLUG UNIT BEFORE
PERFORMING ANY MAINTENANCE.
3