Performance Motion Devices CME N Series, User Manual

Page: 16 / 70

16 ION/CME N-Series Digital Drive Developer Kit User Manual
1
Figure 1-6:
Ethernet Host
Interface DK
Interconnect
Board
The following table identifies these components:
1.9 Connecting the Board
Before operating the developer kit the interconnect board must be connected to your PC, the motor hardware, and
any other motor/machine peripherals to be used with the N-Series ION in your application. For the first time
installation a relatively minimal set of connections are needed which are summarized in
Section 1.9.1, “Connection
Summary.” In subsequent sections detailed pinouts for all of the DK board connectors and associated signals are
provided.
1.9.1 Connection Summary
Figures 1-7 through 1-9 provides general connection overviews for Brushless DC, DC Brush, and step motors. These
diagrams do not show all possible connections or operational modes, but show a typical minimal set of connections
that may be used with this first-time installation of the N-Series ION.
Label Description
J1 HV Power Connector
J2 Motor Drive Connector
J3 Feedback Connector
J4 Hall Signals Connector
J5 Auxiliary Connector
J6 Motion Signals Connector
J7 Indexer Connector
J8 Host SPI Connector (CAN/SPI DK version only)
J9 Programming Connector
J10 Host CAN Connector (CAN/SPI DK version only)
J11 Expansion CAN Connector
J12 Host Serial Connector (Serial DK version only)
J13 Host Ethernet Connector (Ethernet DK version only)
J15 Host Serial Header Connector (Serial DK version only)
U1A N-Series ION Signal Connector pins
U1B N-Series ION Power Connector pins
C1, C2 HV Capacitors
J9
J11-1
J11-2
J1 J2
J7
J6
J5 J4 J3
C1
C2
U1B
U1A
J13