5621 Firethorne Drive
5621 Firethorne Drive
Bay City, MI 48706
Bay City, MI 48706
Ph. 248-705-5395
Ph. 248-705-5395
5621 Firethorne Drive
5621 Firethorne Drive
Bay City, MI 48706
Bay City, MI 48706
Ph. 248-705-5395
Ph. 248-705-5395
www.PerformanceGamesInc.com
www.PerformanceGamesInc.com
ASSEMBLY PROCEDURE:
Step 3: Attach the Blower Motor
• Locate the blower motor, gasket and (3) mounting bolts.
• Place the gasket between the blower motor and the air chamber surface located in the center of the
bottom side of the playfield.
• Line up the holes in the base of the blower with the pre-drilled holes in the air chamber and tighten
all (3) bolts.
• Plug the blower motor into the power strip mounted on the under side of the table.
Step 4: Flip Table Over
• Check that all the leg levelers are screwed all the way into the legs.
• Carefully lift up and rotate the table onto its legs.
* DO NOT ALLOW WEIGHT OF TABLE TO ROCK ON ANY ONE OR TWO LEGS ALONE.
* We recommend that (2) or more people lift the table together.
Step 5: Electronic Scoring Unit Assembly
• Remove the (3) plastic caps located on the center of the one top side rail of the table.
• Attach the scoring unit to the top rail using the (2) bolts, (2) washers, (2) nuts and (2) long screws
provided.
* The (1) small screw is for the IceBoxx game and should be disregarded.
• Locate the (2) wires coming from the infrared sensors and thread them through the largest hole.
* The scoring unit can be powered either by plugging the provided AC adaptor into the power strip
or by using (4) AA batteries (not included).
• Plug in the AC adaptor to the power strip attached to the bottom of the table.
• Thread the smaller end of the AC adaptor cord through the largest hole in the top rail (where the 2
other wires were placed).
• Connect all (3) wires to the scoring unit.
• Test that the sensor wires are correctly attached by shooting a puck into one of the goal openings.
• If the scored goal credits the wrong team, simply switch the identical wires as they were plugged
into the wrong position.
• Line up the holes of the scoring unit with the smaller holes on the side rails. Fasten both screws
with a Phillips head screw driver.
Step 6: Scoring Unit Operation
• Turn the power switch to the ON position.
• Select the desired game option. (Game defaults to the 15 MINUTE
game.)
• To change the game options, push the SELECT button until the desired game is shown.
• There are (7) game options including FREE PLAY which has no time limit or scoring limit.
• After choosing the game option, push the RESET/START button to begin play.
• If you want to start over, press the RESET/START button again.
• There are (3) volume setting on the unit—HIGH, LOW and OFF.
2
