Perfomance Tool W1645, Owner'S Manual, Page: 2 / 8

SAFETY GUIDELINES / DEFINITIONS
UNPACKING AND INSPECTION
SPECIFICATIONS
Specifications are subject to change without notice.
WARNING: Read and understand this entire instruction manual before attempting to assemble, install, operate or
maintain this product. Failure to comply with the instructions may result in serious personal injury
and/or property damage!
The following signal words are used to emphasize safety warnings that must be followed when using this
product:
This instruction manual is intended for your benefit. Please read and follow the safety, installation, maintenance and troubleshooting steps
described within to ensure your safety and satisfaction. The contents of this instruction manual are based upon the latest product information
available at the time of publication. The manufacturer reserves the right to make product changes at any time without notice.
DANGER Indicates an imminently hazardous situation that, if
not avoided, WILL result in death or serious injury.
WARNING Indicates a potentially hazardous situation that, if
not avoided, COULD result in death or serious injury.
CAUTION Indicates a potentially hazardous situation that, if
not avoided, MAY result in minor or moderate injury.
NOTICE Indicates important information, which if not followed,
MAY cause damage to equipment.
After opening the carton, unpack your new product and related parts & accessories. Please inspect it carefully for
any damage that may have occurred during transit.
Packing List
NO. Description Qty.
1 Handle Tube 1 1
2 Handle Tube 2 1
3 Jack Body 1
4 Instruction Manual 1
1. Unscrew the bolt (A) from handle tube 1, Insert the upper
handle into the lower handle. Secure the two pieces
together with the bolt.
2. The handle socket is depressed and secured for
transportation. Insert the handle tube into the handle
socket and press the handle. While pressing the
handle cut the tie with scissors.
3. Undo the screw (B) in the handle socket, until it no
longer protrudes into the handle socket.
4. Insert the pump handle into the handle socket hole completely.
5. Ensure that the handle is correctly inserted into the socket,
then tighten the handle socket screw (B).
Make sure that the handle can be turn smoothly.
WARNING DO NOT operate this product if damaged during shipment, handling or misuse. Do not operate the product until the parts
have been replaced or the fault rectified. Failure to do so may result in serious personal injury or property damage. All damaged parts
must be repaired or replaced as needed prior to operating this product. Check to see that all nuts, bolts and fittings are secure before
putting this product into service. .
Please have the serial number, model number, and date of purchase available for reference when calling.
Capacity: ............................................................................................................. 7,000 lbs.
Minimum Lift Height: ............................................................................................. 3 1/2 in.
Maximum Lift Height: .......................................................................................... 20 1/2 in.
Base Length: ........................................................................................................ 28 3/8 in.
Base Width: ................................................................................................................ 15 in.
ASSEMBLY
1
2
3
4
A
B
2