Phone: 218.828.3700
www.nexlight.com
Fax: 218.824.1568
© 2015 NexLight Lighting Controls, All Rights Reserved.
2
Sensor Adjustments Console:
Sets the infrared range
Range setting
Full CCW = min.(OFF)
Full CW = max.
Passive Infrared Adjustment
Delayed-OFF time
Daylight Sensor Adjustment
Factory default setting is disabled. If installed
location calls for the use of daylight sensor this is
the adjustment for control of required ambient
light levels necessary to disable the automatic
ON control of the sensor when detecting occu-
pancy. NOTE: The daylight sensor function is not
applicable in rooms using manual ON control.
SWITCH FUNCTIONS
Bank A
OFF
ON
Walk Through
Walk Through Enable Walk Through Disable
-
-
-
Mode
Bank B
Disable
Enable
LEDs Mode
LEDs Enabled
LEDs Disable
Test Mode
OFF
ON
OFF = Enter/Exit Test Mode
N/A
N/A
N/A
SWITCH SETTINGS
SWITCH
A1
A2
A3
A4
B1
B2
B3
B4
N/A
N/A
N/A
N/A
N/A
N/A
All aspects of sensor operation can be adjusted here.
View of adjustments when cover is removed. Dip
Switch setting table below illustrates how to enable
and disable sensor functions.
DIP SWITCH SETTINGS
Each time motion is detected, the lights remain
activated for a pre-set time, which is set by the
Off-time adjustment. The fully counter-clockwise
setting (30seconds) can be used for testing. If
motion is detected during the ON time, the timer
resets and lights will remain on until the full
PIR sensitivity can be dialed up or down to meet
the exact needs of anyspace. This adjustment is
helpful to ensure detection in all areas during a
walk test.
N/A
N/A
N/A
Daylight Mode
Daylight Mode
Daylight Mode
Note: Gray indicated factory default settings
Summary of Contents for PS-HC24-R
Page 3: ......
