INS8143A
industrial
ATX
MB
50
Select this option to set the VCC 1.5V parameters.
VTT 1.2V
Select this option to set the VTT 1.2V parameters.
VCC 1.1V
Select this option to set the VCC 1.1V parameters.
DRAM Voltage
Select this option to set the DRAM Voltage parameters.
Warning
: Setting the value too high may cause system to malfunction.
4.12 Password Setting
A supervisor and user password can be configured.
Supervisor password:
Has access and authority to enter and change the
settings in the setup menus.
User password:
Has access to enter the setup menus but does not have
the authority to change the settings.
When this option is selected, the following message appears at the center of
the screen to create a password.
Enter Password:
To create a password, perform the following:
1. Create a password up to eight characters in length and press <Enter>.
The new password will clear any previously entered password from the
CMOS memory.
2. Confirm the password. Type the password again and press <Enter>.
Press <Esc> to abort the selection and not enter a password.
Disable a Password
To disable a password, press <Enter> when prompted to enter a password. A
message will confirm that the password will be disabled. Once the password
is disabled, the system will boot and the setup menu can be accessed without
a password.
Enable a Password
When a password has been enabled, it must be entered each time the Setup
menu is accessed. This prevents unauthorized use or modification to any part
of the system configuration.
