18
17
AUX-IN MODE
A 3.5mm stereo Aux-In socket is provided on the side behind the rubber cover, for connecting an external audio device such as MP3
player or CD player (Aux cable not included with this radio).
1. Connect an audio source to the
AUX-IN
socket.
2. Press the
SOURCE
button to select AUX input. Display will show “AUX IN”.
3. Play the external player.
4. Adjust the
VOLUME
of both the radio and the player for comfortable listening.
5. After use, close the rubber cover to prevent moist or dust from entering into the sockets and radio.
Notes:
Never use the Aux-In socket in rainy or moist conditions to prevent moist from entering the radio. Keep the rubber cover well
closed under these conditions.
The Auto-Power management function will be activated in AUX mode. If there is no signal* from the Aux-In socket for a period of
over 15 minutes, the
DigiTube
radio will automatically switch to standby mode. Pressing the
On/Off
button will wake up the unit.
* Also when the incoming signal from the external device is too low and cannot be detected for a period of over 15 minutes by the
Auto-Power management, the
DigiTube
radio will switch to standby mode.
To prevent this raise the output level of the external device enough to be detected.
MANUALLY SETTING CLOCK
The clock can only be manually set when the radio is in standby mode. If no buttons are pressed for 5 seconds, the radio will exit the
clock setup and the setting is cancelled.
1. Press the
MENU
button for about 3 seconds, and the display will show “CLOCK SET”.
2. Press the
SELECT-INFO
button. The hour digits flash on the display.
3. Press the
TUNING
or
buttons to set the hour
4. Press the
SELECT-INFO
button to confirm. The minute digits flash.
5. Press the
TUNING
or
buttons to set the minute.
Bluetooth LED
The menu of the radio can be configured to Bluetooth LED.
1. Press the
On/Off
button to turn on the radio.
2. Press the
MENU
button, and then press the
Tuning
or
buttons until the display shows “System”.
3. Press the
SELECT-INFO
button; then press the
Tuning
or
button until the display shows “Bluetooth LED”.
4. Press the
SELECT-INFO
button to enter the Bluetooth LED adjustment menu.
5. Press the
Tuning
or
buttons to select “on” (by default) in order to keep Bluetooth LED lightened when connected;
6. Or Press the
Tuning
or
buttons to select “off” to turn off Bluetooth LED when Bluetooth connection has been
established.
7. Press the
SELECT-INFO
button to confirm your choice. The Bluetooth LED will be changed upon the latest selection.
G B
GB