Customer Service Hotline 1-877-693-PURE
Page 4
Home Master® Reverse Osmosis System—Owners Manual
Installing The Home Master® Reverse Osmosis System
1. Mount RO Faucet
1. Use existing spray hose hole, or Drill 1/2”
hole in sink top. See page 3.
2. Slide escutcheon plate onto faucet shank.
3. Slide rubber washer onto faucet shank.
4. Insert shank through hole in sink.
5. Slide locating washer, followed by locking
washer onto shank under sink.
6. Thread brass nut onto shank, position
faucet and tighten nut.
7. Wrap threaded shank with Teflon tape 5-7
times.
8. Hand tighten the 3/8” RO faucet adapter
2. Install EZ adapter on cold water line
-
Always wear protective eyewear while under
sink. Locate the cold water angle-stop (the
main water lines under the sink – one hot
water, one cold water), and turn clock-wise to
shut off the water. Locate 3/8” fitting, typically
found on the line out of the angle-stop or where
the existing line connects to the kitchen faucet.
Disconnect the 3/8” fitting on either the angle-
stop or the kitchen faucet. Use Teflon tape on
the EZ adapter and the angle-stop male
threads, and make sure o-rings are properly
seated. Fit the EZ adapter and tighten. Make
sure EZ adapter ball valve is in the closed
position then check for water pressure & leaks on ball valve. Close EZ adapter valve, by turning
the handle perpendicular to the tube opening as shown below. Open angle-stop valve by rotating
angle-stop counter-clockwise. Have a bowl or cup nearby to catch water. Dry all parts, check for
leaks, and snugness.
VIDEO INSTALLATION INSTRUCTIONS AVAILABLE ONLINE
Faucet Adapter
EZ Adapter on angle-stop
Tank Shut-off
Customer Service Hotline 1-877-693-PURE
Page 13
Home Master® Reverse Osmosis System—Owners Manual