8
9
Multi-Gym
®
Adjustments
STEP 3
a) While the assembly is in front of you as shown, Attach the Connector Bar to the LEFT and
RIGHT Curved Tube Assemblies. Make sure to line up the holes of the connector bar with the
holes on the Curved Tube Assemblies.
b) Insert the SHORT Allen Bolt through the hole in front of the Connector Bar, and in the hole
in the Curved Tube Assembly. Insert an Allen Nut into the hole on the back of the Connector
Bar and hand tighten.
c) Repeat step “ B” for both sides of the Connector Bar and Curved Tube Assemblites.
d) Once all of the components are assembled, use the two Allen Wrenches provided to tighten
all of the nuts and bolts.
NOTE: Doorway Installation
is necessary before tightening
all Acorn Nut assemblies.
1) Identify Front and Back of unit.
2) Inside and outside of Doorway.
Installation Of Your Multi-Gym
®
Before installing in the doorway you will be using, acquaint yourself with the photos and
definitions below. Please remember, this product is designed for installation on up-to
building-code, wood-frame doorways, 27 to 33 inches (69 - 84 cm) wide and for use by
individuals weighing not more than 300 lbs/136 kg.
a
b
Handlebars
Connecting Bar
Short Al
len Bolt
Allen Nut
Short Alle
n Bolt
Allen Nut
Outside of Doorway
Inside of Doorway
Front side of unit
Back side of unit
Door frames and trim (molding) vary in size. The Perfect Multi-Gym
®
has 2 adjustments
to accommodate different molding heights (Figures A and B) and 2 adjustments to
accommodate different doorway thicknesses (Figures C and D).
STEP 1 - Fitting the Multi-Gym
®
to your Doorway
After assembling the unit, try it in the door. You may need to move the bolt positions to get a
proper fit. The unit is correctly fitted in the doorway when it sits snugly at the top of the door
frame and the Hand Grips are level with the floor.
Warning: Remove the Multi-Gym
®
from the door frame
before making any Bolt adjustments. Failure to follow this
instruction may result in serious injury or death.
a) From the outside of the doorway (the side that does not
have the hinges), angle the Connecting Bar end through the
doorway and over the molding on the opposite side (the inside
of the doorway).
b) Adjust the Left and Right Bar Assemblies to match the
thickness of the doorway. When properly adjusted, the Black
Pads on the Left and Right Bar Assemblies should be flush
with the wall and molding. See Figures C and D shown above.
c) Adjust the Connecting Bar to match the width of the door
molding. See Figures A and B shown above. If the fit is too
loose, it will appear like the Incorrect Position shown in Figure
E. You will need to move the Left and Right Bar Assembly away
from the Hand Grip.
d) After all adjustments have been made, see Figure F for
correct positioning. Tighten the 2 Long and 2 Short Allen Bolts
with tool provided. Refer to page 7, Step 2b and page 8, Step
3b.
Doorway Installation
D
C
A
B
2
Adjustment
Holes
Connecting
Bar
Short
Molding
2 A
djustment
Holes
Connecting
Bar
Tall
Molding
2 A
djustment
Holes
2 A
djustment
Holes
Right & Left
Bar Assembly
Narrow Doorway
Right & Left
Bar Assembly
Narrow Doorway
E
F
of Doorway
Inside
of Doorway
Outside
Front
of Unit
Back
of Unit
of Doorway
Inside
of Doorway
Outside
Front
of Unit
Back
of Unit
