Perfect Aire 1PDQW45, User Manual

Page: 10 / 16

7
CONTROL PADS ON THE DEHUMIDIFIER
NOTE: The control panel of the unit you purchased
may be slightly different depending on the model.
8
2
7 6 5 4 3
1
CONTROL PADS: When you push the button to change
operation modes, the unit will make a single “beep”
sound to indicate that it is changing modes.
1. POWER – Press to turn the dehumidifier on and off.
2. LED DISPLAY – Shows the set % humidity level
from 35% to 85% or auto on/off time (0-24) while
setting, then shows the actual ( +/- 5% accuracy)
room % humidity level in a range of 30%RH to
90%RH (Relative Humidity).
3. / : LEFT/RIGHT (DOWN/UP) PADS /
HUMIDITY SET CONTROL PADS
• The humidity level can be set within a range
of 35%RH to 85%RH (Relative Humidity) in
5% increments when in Normal mode.
• For drier air, press the pad and set to a lower
percent value (%).
• For damper air, press the pad and set a higher
percent value (%).
• The recommended standard setting is 45-50%.
You must be on Normal mode to set the humidity
• Cannot be used on Comfort or Cont. mode.
4. TIMER – Press to initiate the Auto on and Auto off
feature, in conjunction with the and key pads.
Timer range is 0.0 – 24 hrs. Timer does not cycle.
Indicator(s) above the button ("On" and/or "Off")
will illuminate when the operation is active.
5. TURBO – Press to select Turbo fan speed for
maximum moisture removal. When the humidity
has been reduced and quiet operation is preferred,
set the fan control to Normal by pressing the
TURBO pad to turn off Turbo fan/light. Indicator
above the button will illuminate when the
operation is active.
6. CONTINUOUS (CONT.) – Press to activate the
continuous dehumidifying operation. When
operating in this mode the LEFT/RIGHT (DOWN/
UP) / pads will be deactivated and you will
NOT be able to set a desired humidity. The unit will
run non-stop unless using the bucket to collect
water. At which point, the unit will shut off when
the bucket is full. Indicator above the button will
illuminate when the operation is active.
7. FILTER – The check filter feature is a reminder to
clean the Air Filter for more efficient operation.
The “Filter” light (Clean Filter Indicator Light) will
illuminate after 250 hours of operation. To reset
after cleaning the filter, press and hold the Filter
button and the light will go off, resetting the timer.
Indicator above the button will illuminate when the
operation is active.
8. COMFORT – Utilize this dehumidification feature to
automatically keep humidity in the 45%–55%
range based on room temperature. When
operating in this mode the LEFT/RIGHT (DOWN/
UP) / pads will be deactivated and you will
NOT be able to set a desired humidity. Indicator
above the button will illuminate when the
operation is active.
NOTE: When neither the Cont. or Comfort mode is
selected, the unit is on Normal mode. The humidity level
can be manually selected in this mode.
FIG. 10