Installation and Operation Manual
for
Perenio®
UV Lamp
Doc Version: 1.0.2
©Perenio IoT spol s r.o. A
ll Rights Reserved
Page
20
из
39
Table 2
–
Recommended Exposure Time
Area of Exposure
Recommended Exposure Time
10m
²
max
15 minutes
20m
²
max
30 minutes
30m
²
max
45 minutes
2.3 Remote Control via Perenio Smart Mobile App
ATTENTION!
The Power Link (PEHPL01- PEHPL04) or the Power Link Wi-Fi
(PEHPL10) device shall be used to control the UV lamp via the Perenio Smart
mobile application.
Below see the way to connect the UV Lamp to the mains, if remotely controlled.
Figure 5
–
Connection to the mains (With Power Link Wi-Fi)
NOTE.
The Power Link (PEHPL01- PEHPL04) device is activated in the mobile app
via the
Perenio®
IoT Router or the Control Gateway, while the Power Link Wi-Fi
(PEHPL10) device is activated directly to the app.
1.
Install the
Perenio Smart
mobile application and activate the Power Link or
Power Link Wi-Fi device (See pars.
A
and
B
below).
2.
Turn off the smart plug and make sure that it is in the
OFF
state in the mobile
application.
3.
Connect the UV lamp to the smart plug using the power cord (See Figure 5
above).
4.
Prepare the room for UV treatment and leave it.
