![background image](http://html.mh-extra.com/html/perel/tc76208/tc76208_user-manual_1528685004.webp)
TC76208
V. 01 – 22/11/2016
4
©Velleman nv
Never use this appliance in a bathroom.
Make sure that no one can touch the device with wet hands.
The device is splash proof.
Always disconnect mains power when device not in use or when servicing or maintenance activities are
performed.
DO NOT disassemble or open the cover. There are no user-serviceable parts inside the device. Refer to an
authorized dealer for service and/or spare parts
Handle the power cord by the plug only.
Check the cable before every use.
Do not use the device when damage to housing or cables is noticed. Do not attempt to service the device
yourself but contact an authorised dealer or service agent.
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
This device is not equipped with a thermostat that turns off the heater when the desired temperature is
reached.
3.
General Guidelines
Refer to the
Velleman® Service and Quality Warranty
on the last pages of this manual.
4.
Unpacking
Check the device when unpacking it.
If the device was damaged in transit, do not install or use it and contact your dealer.
Do not dispose of the packing. The packing can be used to protect the device when not used for a long time
or for shipping purposes.
Remove all package material and check the appliance for damages. Always clean up the package material.
It could be life threatening for children and animals.
Install the appliance on a secure and firm surface. Do not expose it to vibrations and heavy wind. Make
sure the surface can carry the device.
5.
Mounting
Refer to the illustrations on page 2 of this manual.
Never plug in the device while mounting it.
Only use mounting material that is suitable for the mounting surface. Please contact a technician if in doubt.
You must strictly follow the minimum safety clearances when mounting the appliance:
Distance to wall : minimum 150 cm
Distance to ceiling : minimum 50-100 cm
Distance to floor : minimum 250 cm
1.
Find a stable and dry location to mount the device.
2.
Respect the safety clearances (see Safety Instructions) when mounting the device.
3.
Slide the lower bar in the stand and attach it.
4.
Slide the middle bar onto the lower bar and attach them.
5.
Slide the upper bar onto the middle bar and attach them.
6.
Slide the heating element on the upper bar and secure it using the knob.
7.
You can set up the heater in an angle between 0° and 45°. Attention: do not change the angle while the
device is in use. First, disconnect the device, let it cool down for 15 minutes and then change the angle.
6.
Overview
Use the chain to switch the device on and off.
The vibrations after switching on the device will stop after some seconds.