Perel PR090012, User Manual, Page: 6 / 25

PR090012
PEREL 6
f. Setting the cutting depth (fig. F)
•
Set the depth stop (10).
•
Slacken the clamp lever (11).
•
Push the device down to the depth stop.
•
Fasten the clamp lever.
g. Quick selecting the cutting depth (fig. F)
Quick-select between pre-set cutting depths by means of the revolver depth stop.
•
Lift the revolver depth stop from its current fixing point and turn the desired cutting depth position to the position
below the depth stop.
•
Make sure the revolver depth stop is secured in the fixing point.
•
Follow the instructions above to set the cutting depth.
h. Switching ON/OFF (fig. A)
•
switching on: press and hold the operating switch
•
Adjust the cutting speeds by means of the dial (13)
•
Switching off: release the operating switch
6. Cleaning and Maintenance
CAUTION:
Disconnect from mains before starting maintenance operation.
1. All screws or parts of the device have to be tightly connected and must not be corroded.
2. There must not be any deformations on the housing and its accessories.
3. Moving mechanic parts must not show any traces of wear and tear and must be able to rotate unimpeded.
4. The electric power supply cables must be free of damage. Have a qualified technician service the device.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. After operation, clean out the ventilation slots with compressed air (3 bar max.) to prevent the buildup of dust.
7. Technical Specifications
Power supply
max. 230V~ / 50Hz
Power consumption 900W
Speed 9000-28000rpm
Cutting depth 52mm
Spindle diameter 6/8mm
Vibration level 5.5m/s²*
Sound pressure level 88dB (A)*
Sound power level 102dB (A)*
Protection class II /
Weight 3kg
* measured according to EN 50144
Note: The EC Declaration of Conformity is attached.
The information in this manual is subject to change without prior notice.