![background image](http://html.mh-extra.com/html/perel/csolmf/csolmf_user-manual_1528564005.webp)
CSOLMF
V. 01 – 03/04/2019
5
©Velleman nv
3.
General Guidelines
Refer to the Velleman
®
Service and Quality Warranty on the
last pages of this manual.
All modifications of the device are forbidden for safety
reasons. Damage caused by user modifications to the device
is not covered by the warranty.
Only use the device for its intended purpose. Using the
device in an unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this
manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or
problems.
Nor Velleman nv nor its dealers can be held responsible for
any damage (extraordinary, incidental or indirect) – of any
nature (financial, physical…) arising from the possession,
use or failure of this product.
Keep this manual for future reference.
4.
Installation
Mounting Location
When the lamp is installed in a location that receives less
sunlight, it will operate for fewer hours per night. Night lighting
time can also vary depending on how bright the sky is on any
given day. Insufficient charging of the battery will affect
performance and may result in premature switching-off due to an
insufficient battery charge. Install the solar panel as much as
possible towards the south in order to maximize exposure to
direct sunlight. Please note that the four different seasons (and
the sun’s angle in these periods) can affect the lighting time of
the lamp. Select a location that is not located close to other light
sources, such as street lighting, because this enables the lamp to
switch off automatically. Maximum lighting time depends on
sunlight and daytime charging.
Installation
1.
Use the card to measure the position of the holes correctly.
Drill two holes.
2.
Insert a nylon plug in each hole.
3.
Insert a screw in the lower nylon plug and tighten slightly.
Insert the lower notch of the lamp onto the screw.
4.
Straighten the lamp and fasten the upper screw.
5.
Press the mode button to adjust the working mode.