CFAN0342S
V. 01 – 26/11/2012
4
©Velleman nv
3.
Loosen and remove the pole connector
[15]
from the lower pole, then slide the pole ornament
[17]
over
the lower pole to cover the screws in the base.
4.
Extend the upper pole
[14]
, slide the pole connector
[15]
back over the poles and tighten it.
5.
Attach the motor
[11]
to the upper pole. Make sure it is pushed as far as possible onto the pole, and
secure it by tightening the knob under the speed buttons.
6.
Loosen the grille mounting nut
[6]
from the motor housing
[9]
.
7.
Position the rear grille
[7]
firmly to the motor housing
[9]
and fasten it with the mounting nut
[6]
.
8.
Push the fan blade
[5]
along the motor shaft
[8]
and fasten it firmly with the spinner
[4]
.
9.
Hang the front grille on the rear grille using the grille clamp
[3]
. Make sure the screw holes in the rims of
the grilles correspond. Fix the grilles together with the screw and the clips on the rim of the front grille.
10.
Fix the grille ornament
[1]
to the front of the grille.
Your fan is now ready for use.
7.
Use
To use the fan:
1.
Place the fan on a flat and sturdy surface. Make sure no objects (e.g. curtains) can be sucked into the rear
of the fan.
2.
Insert the power plug into the mains.
3.
To adjust the height, hold the upper pole
[14]
and loosen the pole connector
[15]
. Slide the upper pole to
the desired height and tighten the pole connector.
4.
Loosen the tilt knob
[12]
and adjust the fan’s tilt position. Tighten the knob again to fix the position.
5.
Set the desired output speed using the speed buttons
[13]
: 0 = stop; 1 = low; 2 = medium; 3 = high.
6.
Push down the oscillation knob
[10]
to make the fan oscillate. Pull up the oscillation knob
[10]
to fix the
fan’s direction.
7.
Always switch off and unplug from the mains before moving the fan.
8.
Switch off and unplug from the mains after use.
8.
Cleaning and maintenance
•
Disconnect the device from the mains prior to maintenance activities.
•
Clean out the parts with a soft and dry cloth. Remove stains with a damp cloth and some mild soap.
Remove soap remnants with the damp cloth. Do not use abrasives.
•
Make sure no water or any other liquid enters the motor assembly
[11]
or the control buttons
[10, 13]
.
•
Keep the ventilation holes of the motor assembly
[11]
free from dust at all times.
9.
Technical Specifications
power supply
230 Vac / 50 Hz
power 50
W
Ø fan
40 cm
power cord length
2 m
airflow
> 51 m³/min.
oscillation arc
75°
height 127
cm
weight 3700
g
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.perel.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
