Install
Instrument
with 1.5m free
space (from
widest point)
around it.
1.5m
1.5m
Surface Fixed
Babel Drum
Page 1 of 2
1. Unpack ground fixing legs
3no.
Installation Instructions
Played with hands
22 Kg
13.4 Kg
Ground Fix
Components:
Weight of heaviest part
17.5kg
(Large Babel Drum)
Weight of heaviest part
13.4kg
(Small Babel Drum)
BS EN 1176
Metric Conversion:
850mm/ 33
15/32
”
855mm/ 33
21/32
”
1.5m/ 59”
CAUTION: Drum
surface can get hot
in direct sunlight, if
possible install in
shaded areas.
2. Lay packaging out on floor
or assemble on non-abrasive
surface to prevent marking of
polished stainless steel.
3. Align holes on legs to holes
on surface fixing(opposite
end to polished domes) and
secure in place using 3no.
M10 x 30mm Screws
provided
Tools required TX 45 Driver
Bit)
4. Invert assembled frame so
domed ends face upwards.
5. Place 8mm Hex Key
supplied into hole in leg and
lock into internal bolt.
6. Remove Black Cap
opposite side of leg and
keeping Hex Key in place,
slide black polyurethane
damper over bolt until flush
with end of bolt. Repeat for
other 2 legs
8. Align holes in side of babel
drum with bolts on legs.
9. Using 8mm Hex Key screw
bolts into drum to secure in
place.
Use thread locking solution
All hole locations are laser cut
for accuracy to ensure holes
in drum align perfectly with
legs.
7. Unpack babel drum leaving
black film in place to protect.
10. Using TX40 driver
provided secure M8 x 25mm
security bolts into external
holes in legs 3no. Use thread
lock solution
Instrument
Components:
M8x25mm Pin Torx
x3
Ground Surface
850mm from Plate
Large 8 note
Small 6 note
11.Locate Babel Drum in
desired location and mark
holes to fix to desired surface.
12. Fix to Surface using
recommended ground
anchors (Ground Anchors are
not supplied)
13. Make sure all fixings are
covered and secure using
cover caps provided
M10x30 Security Screw
x3
2 Part Cover Cap
x4
Ground Anchors
not supplied
Spares available from
percussionplay.com
or from your
local distributor
855mm from Plate
